HomeMy WebLinkAbout12 48 13 Entrance Floor Mats.DOCPEDCOR SQUARE; BUILDING 5
12 48 13 -
PEDCOR SQUARE Issue Date: 12.28.15 ENTRANCE FLOOR MATS
PEDCOR SQUARE; BUILDING 5
SECTION 12 48 13 - ENTRANCE FLOOR MATS AND FRAMES
PART 1 - GENERAL
1.1 RELATED DOCUMENTS
A. Drawings and general provisions of the Contract, including General and Supplementary
Conditions and Division 01 Specification Sections, apply to this Section.
1.2 SUMMARY
A. Section Includes:
1. Resilient entrance mats.
1.3 ACTION SUBMITTALS
A. Product Data: For each type of product.
B. Samples: For the following products, in manufacturer's standard sizes:
1. Floor Mat: Assembled sections of floor mat.
1.4 CLOSEOUT SUBMITTALS
A. Maintenance Data: For floor mats to include in maintenance manuals.
PART 2 - PRODUCTS
2.1 ENTRANCE FLOOR MATS, GENERAL
A. Regulatory Requirements: Comply with applicable provisions in the U.S. Architectural &
Transportation Barriers Compliance Board's ADA-ABA Accessibility Guidelines for Buildings and
Facilities and ICC A117.1.
2.2 RESILIENT ENTRANCE MATS
A. Carpet-Type Mats: Nylon or Polypropylene carpet bonded to 1/8- to 1/4-inch- thick, flexible vinyl
backing to form mats 3/8 or 7/16 inch thick with non-raveling edges.
1. Colors, Textures, and Patterns: Refer to Finish Legend on Drawings.
2. Mat Size: As indicated.
PEDCOR SQUARE; BUILDING 5
12 48 13 -
PEDCOR SQUARE Issue Date: 12.28.15 ENTRANCE FLOOR MATS
PEDCOR SQUARE; BUILDING 5
2.3 FABRICATION
A. Floor Mats: Shop fabricate units to greatest extent possible in sizes indicated. Unless otherwise
indicated, provide single unit for each mat installation; do not exceed manufacturer's
recommended maximum sizes for units that are removed for maintenance and cleaning. Where
joints in mats are necessary, space symmetrically and away from normal traffic lanes. Miter
corner joints in framing elements with hairline joints or provide prefabricated corner units without
joints.
PART 3 - EXECUTION
3.1 EXAMINATION
A. Examine substrates and floor conditions for compliance with requirements for location, sizes,
and other conditions affecting installation of floor mats.
B. Proceed with installation only after unsatisfactory conditions have been corrected.
3.2 INSTALLATION
A. Install surface-type units to comply with manufacturer's written instructions at locations
indicated; coordinate with entrance locations and traffic patterns.
1. Anchor fixed surface-type frame members to floor with devices spaced as recommended
by manufacturer.
3.3 PROTECTION
A. Maintain protection until construction traffic has ended and Project is near Substantial
Completion.
END OF SECTION 12 48 13