HomeMy WebLinkAboutM003.02x4 Ledger
2x4 Ledger
2x4 Ledger
2x4 Ledger
2x4 LedgerGBFB F1BRBR1BGGG(3)
F(2)F1(5)
R(7)R1(6)2-00-002-00-002-00-002-00-002-00-002-00-002-00-002-00-002-00-002-00-002-00-002-00-002-00-002-00-002-00-001-08-082-00-002-00-002-00-001-08-082-00-002-00-002-00-002-00-002-00-00CB
C1B
C
AB
AF
BB
B
A1B
A(13)A(7)2-00-00
1-00-00
2-00-00
2-00-00
2-00-00
2-00-00
2-00-00
2-00-00
1-07-08
2-00-00
2-00-00
1-00-00
2-00-00
2-00-00
2-00-00
2-00-00
11-00
2-00-00
2-00-00
2-00-00
2-00-00
2-00-00
2-00-00
1-08-00
2-00-00
1-04-00
2-00-00
Order #: 1808016
The Grove at Legacy - 29
Carmel, Indiana 46033
Carter Lumber
2901 N. Morton St.
Franklin, Indiana 46131
(317) 346-1300
THIS IS A TRUSS PLACEMENT DIAGRAM ONLY.These trusses are designed as individual building components to be incorporated
into the building design at the specification of the buildingdesigner. Seeindividualdesignsheetsforeachtrussdesign identified onthe placement drawing. The building designer is responsiblefortemporaryandpermanentbracingoftheroofandfloorsystem andfor the overall structure. The design of the truss support structure including headers, beams, walls, and columns is the responsibility of
the building designer. For general guidance regarding bracing, consult "Bracing of Wood Trusses" available from the Truss PlateInstitute, 583 D'Onifrio Drive; Madison, WI 53179.
SHOP DRAWING APPROVALTHIS LAYOUT IS THE SOLE SOURCE FOR FABRICATION OF TRUSSES AND VOIDS ALL PREVIOUS ARCHITECTURAL OROTHER TRUSS LAYOUTS. REVIEW AND APPROVAL OF THIS LAYOUT MUST BE RECEIVED BEFORE ANY TRUSSES WILL
BE BUILT. VERIFY ALL CONDITIONS TO INSURE AGAINST CHANGES THAT WILL RESULT IN EXTRA CHARGES TO YOU.
REVIEWED BY:__________________________ APPROVED BY:______________________________ DATE:___________
Pyatt Builders
Scale: NTS Drawn By: K. BronnenbergDate: 8/9/18
Model
SOHO
Notes:
1) Valley trusses are designed to sit on sheathing.
2) Installation of all temporary and permanent braces is essential.
See truss drawings, BCSI-1 Building Component Safety informationand building designers requirements.
3) Provide solid bearing for beams and girders. See Code and/or
building deigners requirements.
4) Truss are NOT designed to be field modified unless notedotherwise. If any alterations are to be considered ALWAYS consultaqualifiedtrussdesignerorengineerBEFOREmakinganyalterations.
5) Add/remove overhangs as needed.
Multi-Ply Girder Truss:
See drawing of multi-ply girders for fastening pattern to connect plysso they act as one. All plys must be fastened together before supported
trusses or framing is attached to girders.
Hangers:Install all hangers per manufacturers requirements.