HomeMy WebLinkAbout08 95 17 Interior Wall VentsTHE KENT
08 95 17 -
THE KENT Issue Date 05.09.18 INTERIOR WALL VENTS
THE KENT
SECTION 08 95 17 – INTERIOR WALL VENTS
PART 1 - GENERAL
1.1 RELATED DOCUMENTS
A. Drawings and general provisions of the Contract, including General and Supplementary
Conditions and Division 01 Specification Sections, apply to this Section.
1.2 SUMMARY
A. Section includes interior wall vents.
1.3 ACTION SUBMITTALS
A. Product Data: For each type of product.
B. Samples: For each type of metal finish required.
PART 2 - PRODUCTS
2.1 MANUFACTURERS
A. Source Limitations: Obtain vents from single source from single manufacturer.
2.2 INTERIOR WALL VENTS
A. Polyurethane Wall Vents:
1. Manufacturers: Subject to compliance with requirements, provide products by the
following:
a. Fypon.
2. Product: Round Louver FRLV24 with RLV24X4F trim.
PART 3 - EXECUTION
3.1 INSTALLATION
A. Locate and place vents level, plumb, and at indicated alignment with adjacent work.
B. Provide perimeter reveals of uniform width for sealants and joint fillers, where indicated.
C. Use concealed anchorages.
THE KENT
08 95 17 -
THE KENT Issue Date 05.09.18 INTERIOR WALL VENTS
THE KENT
3.2 ADJUSTING AND CLEANING
A. Before final inspection, clean exposed surfaces with water and a mild soap or detergent not
harmful to finishes. Thoroughly rinse surfaces and dry.
B. Restore vents damaged during installation and construction so no evidence remains of
corrective work. If results of restoration are unsuccessful, as determined by Architect, remove
damaged units and replace with new units.
END OF SECTION 08 95 17