HomeMy WebLinkAbout15. FLOOR PLAN A1.2RELEASED FOR CONSTRUCTION
Subject to compliance with all regulations
of State and Local Codes
City of Camel
�VT�L21�8*541WMt_
DATE: \ 09/06/19
SECOND FLOOR PLAN 2 N
114" = 1'4"
VESTIBULE
FIRST FLOOR PLAN I N
114' = 1' 0"
LOBBY
GENERAL NOTES
A. CONTRACTOR SHALL BE RESPONSIBLE FOR VERIFICATION
OF ALL DIMENSIONS AND JOB CONDITIONS. ANY DEVIATION
FROM WHAT IS NOTED IN DRAWINGS SHALL BE BROUGHT
TO THE ATTENTION OF THE ARCHITECT IMMEDIATELY.
B. ALL DIMENSIONS SHOWN ARE FACE OF BRICK, MASONRY
OR METAL STUD FRAMING -UNLESS NOTED OTHERWISE.
C. PROVIDE DEEP LEG DEFLECTION TRACK AT ALL METAL
STUD CONNECTIONS WITH STRUCTURE ABOVE -TYPICAL.
D. PROVIDE FIRE RATED WOOD BLOCKING IN METAL STUD
WALLS FOR ANY WALL SUPPORTED ITEMS.
E. PROVIDE APPROVED FIRE RATED STOPPING MATERIALS IN
ANY OPENINGS IN FIRE RATED ASSEMBLIES.
F. REFER TO DOOR AND WINDOW SCHEDULES FOR ALL
MATERIALS, FINISHES AND HARDWARE INFORMATION.
G. ALL MATERIALS LOCATED IN CEILING PLENUM SHALL BE
RATED FOR SUCH INSTALLATION OR PROTECTED TO
PROVIDE COMPLIANCE. THIS INCLUDES BUT IS NOT LIMITED
TO POWER AND LOW VOLTAGE WIRING,
TELECOMMUNICATIONS CABLING, PLUMBING SUPPLY AND
DRAIN LINES AND SUPPORTING BRACKETS AND/OR
BLOCKING FOR CEILING HUNG ITEMS.
H. PRIOR TO ORDERING ANY PRODUCTS -CONTRACTOR SHALL
SUBMIT SAMPLES TO THE ARCHITECT OF ALL FINISH
MATERIALS TO BE USED ON THE PROJECT. THE
CONTRACTOR SHALL BEAR SOLE RESPONSIBILITY FOR ANY
MATERIALS ORDERED INCORRECTLY WHEN THAT MATERIAL
WAS NOT REVIEWED BY THE ARCHITECT.
I. ALL DOORS, UNLESS OTHERWISE NOTED, TO HAVE HINGE
SIDE SET 4" FROM CORNER SHOWN TO OUTSIDE OF
FRAME
KEYED NOTES
I. NEW 8" CMU ELEVATOR SHAFT WALL TO ALIGN W/
EDGE OF EXISTING STRUCTURE AND OPENING ABOVE.
COORDINATE W/ STRUCTURAL DRWGS. WALL TO EXTEND
TO BOTTOM OF FLOOR ABOVE.
2. NEW 42" TALL GUARDRAIL W/ MAX. OPENING SIZES
LESS THAN 4' CLEAR. REFER TO INTERIOR DRWGS.
FOR MORE INFORMATION.
3. PROVIDE HAT CHANNEL FURRING WITH ONE LAYER OF
I" GYPSUM BOARD AND VAPOR BARRIER OVER NEW 8"
CMU WALL. REFER TO INTERIOR DRWGS. FOR FINISH
SCHEDULE FOR WALL FINISH.
4. NEW INFILL AND CONCRETE FLOOR IN ELEVATOR
SHAFLREFER STRUCTURAL DRWGS. FOR MORE
INFORMATION, FLOOR TO BE 4'-0" BELOW TOP OF
FIRST FLOOR SLAB. REFER TO ELEVATOR
MANUFACTURES SPECS FOR CLEARANCE
REQUIREMENTS.
5. EXISTING STAIR TO REMAIN. NO NEW WORK.
6. NEW HYDRAULIC ELEVATOR. MANUFACTURER:
THYSSENKRUPP MODEL: ENDURA 25 A REFER TO
ELEVATOR MANUFACTURERS SPECIFICATIONS FOR ALL
ELEVATOR REQUIREMENTS.
7. ALIGN FINISHED FACE NEW WALL WITH EXISTING.
8. PATCH AND REPAIR CEILING AS REQUIRED TO MATCH
EXISTING WHERE REMOVED OR DAMAGED FOR SHAFT
INSTALLATION.
FAST CARMEL DRIVE
I.J PROJECT LOCATION
N KEY PLAN
ORTH
CURRAN
ARCHITECTURE
6925 EAST 96TH ST., SUITE 105
INDIANAPOLIS, IN 46250
O :: 317. 288.0681
F :: 317. 288. 0753
>°y`2`P�e`IM ea oUPq
No. y
• AR19600043'. •
STAR 0' _
THS DRAWING AND THE IDEAS. DESIGNS
AND CONCB'TS CONTAINED HERON ARE
THE EXCLUSIVE INTELLECTUAL PROPERTY
OF CURRAN ARCHITECRIRE, AND ARE NOT
TO BE USED OR REPRODUCED, WHOLE OR
IN PART, WITH WT THE WRITTEN
CONSENT OF CURRAN ARCHITKTME.
Q CO%RCHT 2017, CURAVY PRCHITECTURE
ELEVATOR ADDITION
101 EAST CARMEL DRIVE
CARMEL, IN
PERMIT SET 7-10-19
170053
FLOOR PLAN
A192