HomeMy WebLinkAbouttruss-001�
��$
MiTek�
MiTek USA, Ine.
16023 Swingley Ridge Rd
Cheste�eld, MO 63017
314-434-1200
Re: QTREC0509373
The truss drawing(s) referenced below have been prepared by MiTek USA, Inc. under my direct supervision
based on the parameters provided by Midwest Manufacturing.
Pages or sheets covered by this seal: T41201711 thru I4] 2017ll
My license renewal date for the state of Indiana is July 31, 2020.
�JEGANG ��G
No.19900415
_ . • —
% '� �� STATE OF ;' ¢ �
'��p�.c �'.�NOIANP••' `��'� `
/�� F ..
V '� �����i�sS'�NA 1`ENG�����
May 5,2020
Liu, Xuegang
�MP�RTANT N�TE: The seal on these truss wmponent designs is a certificallon
that the engineer named is licensed in the junsdiction(s) identified and that the
designs comply with ANSIRPI 1. These designs are based upon parameters
shown (e.g., loads, supports, dimensions, shapes and design codes), which were
given to MiTek or TRENCO. Any project specific information included is for MiTek's or
TRENCO's customers file reference purpose only, and was not taken into accoun[ in the
preparetion of these designs. MiTek or TRENCO has not independently verifietl the
applicability of the design parameters or the designs for any particular building. Before use,
ihe building designer should verify applicability of design parameters and properly
incorporate these designs into the overall building design per ANSIlTPI 1, Chapter 2.